Jump to content

Recommended Posts

mairj40    6

I picked up a 60's Harmony H39 on Craigslist today. It needs a bit of work. It is missing the cable that runs from the control knob to the jack that plugs into an amp. The neck was starting to separate from the body some. I got it home and took all the hardware off and steamed the neck off. The action was HORRIBLE. When I put a straightedge on the fretboard to the bridge, the straightedge is about 1/2" below the top edge of the bridge. Is it the same with an archtop hollow body as it is with other guitars, where the edge of the straightedge should rest on the top of the bridge? Hopefully I am making sense.

1008161448a_zps8s88wzge.jpg

1008161448_zpshwziqqpy.jpg

1008161449_zpsaqqv8uvh.jpg

Share this post


Link to post
Share on other sites
curtisa    426

I have no experience with archtop guitars, but I don't see why the straightedge method wouldn't be valid as it is with flat top acoustic guitars.

So yes, In my head the straightedge should rest on top of the saddle when laid on the fretboard. If not, then the same faults that cause this issue in acoustic guitars would need to be addressed - warped neck, truss rod needs adjusting, failing neck joint, neck reset, top warped/bellied etc

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


×