Want Your Input Jack to look Like a Jem?

by Brian Calvert

Below are the Only tools you will need besides Safety Glasses...

First Drill a Pilot Hole using a 1/4" bit......

Then Using your 3/4" wood bit drill till you are within 3/4" from the inside cavity

Finally Re-drill the existing pilot hole all the way through using a 1/2" bit

Using a 1/2" wood dowel cut to length glue and fill the old input hole

Cover,Seal and Sand the old whole and smooth out any problems with the new one using Epoxy Paste

Now Your Through =o)

Prime the Body and Nobody will know it was not Original