Electronics Chat

5,657 topics in this forum

1. Sustainer Ideas 1 2 3 4 190

   By psw, May 1, 2004
   • 4.7k replies
   • 527.6k views
   • 
   • roseblood11
   • August 6, 2020

2. Diagram Explanation???

   By kyle, June 13, 2004
   • 6 replies
   • 9.4k views
   • 
   • gatay
   • December 27, 2009

3. swapping out toggle switch for push-button. Will it work?

   By levitator, January 10
   • 4 replies
   • 36 views
   • 
   • Bizman62
   • Thursday at 04:33 PM

4. Best humbuckers for solidbody...

   By bimmermanshane, Tuesday at 07:12 PM
   • 5 replies
   • 31 views
   • 
   • bimmermanshane
   • Wednesday at 05:04 PM

5. Help with electrickery for a newbie

   By Lee Parkes, January 7
   • 5 replies
   • 45 views
   • 
   • Lee Parkes
   • January 9

6. 3 Humbuckers, 5 Way Switch Wiring

   By Clown, January 8
   • 1 reply
   • 22 views
   • 
   • curtisa
   • January 8

7. Gibson 345 varitone wiring

   By scorpionscar, April 13, 2020
   • 6 replies
   • 141 views
   • 
   • MiKro
   • January 7

8. Bad Jack, or Ground wiring issue?

   By CC1, December 19, 2020
   • 14 replies
   • 79 views
   • 
   • Bizman62
   • December 22, 2020

9. ok, so say you had to wire this up in a 339... and you were aware of the unshielded-ness of the situation...

   By mistermikev, December 17, 2020
   • 3 replies
   • 39 views
   • 
   • mistermikev
   • December 17, 2020

10. guitar cutout or amp cutout

    By simon1138, November 15, 2020
    • 1 reply
    • 87 views
    • 
    • Bizman62
    • November 15, 2020

11. Highs disappear when turning down volume

    By levitator, October 30, 2020
    • 1 reply
    • 126 views
    • 
    • Bizman62
    • October 30, 2020

12. Potentiometers for Active Bass

    By kohlhosein, October 24, 2020
    • 2 replies
    • 88 views
    • 
    • mistermikev
    • October 25, 2020

13. Tele - Low Cut and 50s/modern switches !

    By aboubou, October 7, 2020
    • 12 replies
    • 194 views
    • 
    • aboubou
    • October 22, 2020

14. Carvin X100B Repair (done) 1 2

    By MiKro, September 7, 2020
    • 46 replies
    • 687 views
    • 
    • MiKro
    • October 9, 2020

15. Is it possible to split the Neck pickup with this wiring?

    By AndreeTheG, September 12, 2020
    • 4 replies
    • 141 views
    • 
    • curtisa
    • September 20, 2020

16. No volume on E string

    By tparker, August 14, 2020
    • 5 replies
    • 143 views
    • 
    • tparker
    • September 15, 2020

17. EMG noisy

    By Co0lCat, September 9, 2020
    • 10 replies
    • 143 views
    • 
    • Co0lCat
    • September 10, 2020

18. Two capacitor one humbucker

    By Heft, September 3, 2020
    • 1 reply
    • 91 views
    • 
    • curtisa
    • September 4, 2020

19. 4 sound humbucker.

    By Heft, September 3, 2020
    • 2 replies
    • 68 views
    • 
    • Heft
    • September 3, 2020

20. two capacitor tele circuit.

    By Heft, September 1, 2020
    • 4 replies
    • 77 views
    • 
    • Heft
    • September 1, 2020

21. Dual coil split and master series/parallel

    By Ig9, August 30, 2020
    • 2 replies
    • 92 views
    • 
    • Ig9
    • August 30, 2020

22. Bridge pup too bright

    By Weldaar, August 27, 2020
    • 4 replies
    • 75 views
    • 
    • ADFinlayson
    • August 29, 2020

23. EMG pickups to ground/earth

    By st. krik, August 26, 2020   

    • emg
    • earth
    • (and 2 more)

      Tagged with:

      • emg
      • earth
      • ground
      • grounding
    • 9 replies
    • 144 views
    • 
    • Prostheta
    • August 27, 2020

24. working sustainer

    By reg-g innit, April 19, 2017   

    • sustainer
    • 14 replies
    • 1.4k views
    • 
    • RLong98
    • August 16, 2020

25. Chasing a 60hz hum, how do these solder points on the jack look?

    By HumChaser, July 21, 2020
    • 2 replies
    • 121 views
    • 
    • HumChaser
    • July 22, 2020