schnarf Posted September 18, 2004 Report Share Posted September 18, 2004 I'm making a neck through. I glued it yesterday. I glued in the neck blank without having cut it out, shaped it, or anything. I realized today when I went to draw stuff on it, that I made the neck-through part 5 cm, and my neck is meant to be 5.6 cm at the 21st fret. Basically, I see two options: I could shift the entire thing back so the bridge will be closer to the neck joint and the 24th fret will be at the very top of the neck joint. This would look bad. The other thing I'm considering is using some scrap from the neck blank to widen the joint where it meets the body. Would this work? Are there any other better solutions? Quote Link to comment Share on other sites More sharing options...
krazyderek Posted September 18, 2004 Report Share Posted September 18, 2004 option 2, yes just glue some more wood on the sides Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.