Jump to content

Truss Rod & Carbin Fiber Rods

Recommended Posts

I think 18" would be ok. Someone else with a little more experience might want to cime in though. I dont know if you have purchased the rods yet, but check this place out; Into The Wind, they have a .24" X 32" rod for $3.90. David Myka uses these. You can rout a 1/4" groove and you're good to go. I ordered a few of these for my project as well as a whitside 1/4" roundnose bit. I think it is gonna work out well, plus its a lot cheaper than the stewmac graphite.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Create New...