daveq Posted July 27, 2003 Report Share Posted July 27, 2003 What do you use for drilling the post holes? It looks like a 10mm might work best but I can't be sure since I don't have one and can't find one locally. Looks like stewmac will be getting yet another donation. Is it true that there are two holes needed (one for the post and one for the adjustable screw)? I thought I read somewhere that two holes were needed for each post? Thanks, Dave Quote Link to comment Share on other sites More sharing options...
krazyderek Posted July 27, 2003 Report Share Posted July 27, 2003 my floyd installation book says { you will drill these holes with a 25/64" (0.391") drill to a depth of 13/16" (0.812") } Quote Link to comment Share on other sites More sharing options...
daveq Posted July 27, 2003 Author Report Share Posted July 27, 2003 Installation book! Where did you get it? 25/64 seemed a bit small - are you supposed to bang it in with a dead-blow hammer? Any more info you can provide would be hugely appreciated! Thanks, Dave Quote Link to comment Share on other sites More sharing options...
Brian Posted July 27, 2003 Report Share Posted July 27, 2003 Actually the anchors very in size from manufacturer to manufacturer so there is no set size you just need to measure the diameter and go from there Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.