iHeart_LesPauls Posted September 3, 2006 Report Share Posted September 3, 2006 Because i'm a noob at wiring I need to find a way to properly install three swinesdead's pickups into my cheap strat like guitar. I want to have one humbucker in the bridge and 2 other single coils in the middle and neck positions. I want to hook it all up with a tone and volume pot to the bridge which I wish to also be Coil tapped with a push pull pot. Then i want the neck and middle pups to be hooked up to the same tone and volume knobs. On top of that where should i hook up the capacitors i have. I have three .o47uf, .022uf and .001 uf.......I want the .047 hooked up to the bridge pup. I've never done this from scratch so i'm kinda clueless but i can understand wiring diagrams. One more thing is it's all hooked up to a 5 way selector. Should i use the tremolo bridge as a COMMON ground for all my grounding's? Thanks if anyone can help with anything it would be much appreciated. P.s. below is a link.... this is the pickups setup. i just want to know the rest. http://static.zoovy.com/img/guitarelectron.../wdu_hss5l11_01 Quote Link to comment Share on other sites More sharing options...
al heeley Posted September 3, 2006 Report Share Posted September 3, 2006 I can't help but I know just the place where they will sketch out for you a custom diagram: http://guitarnuts2.proboards45.com/index.cgi? Quote Link to comment Share on other sites More sharing options...
johnsilver Posted September 3, 2006 Report Share Posted September 3, 2006 Try this If that isn't it exactly, there are plenty of other diagrams on the Seymour Duncan site. You could always contact the manufacturer of your pups as well. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.