sbskates Posted November 25, 2006 Report Share Posted November 25, 2006 i have been using my router with a pattern trim bit and a guide edge to cut things nice straight flush etc. i was thinking of doing this on my ebony fretboarded newly built neck . will it chip because ebony is so hard or will it be ok? Quote Link to comment Share on other sites More sharing options...
erikbojerik Posted November 26, 2006 Report Share Posted November 26, 2006 i have been using my router with a pattern trim bit and a guide edge to cut things nice straight flush etc. i was thinking of doing this on my ebony fretboarded newly built neck . will it chip because ebony is so hard or will it be ok? Bandsaw it to within 1/8" of the line, then rout it. Should be fine. You mainly get router chips when you try to remove too much material, i.e. the bit takes too big a bite. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.