Jump to content

Need Telecaster Neck Pocket Templates(printable)

Recommended Posts

I just finished a Tele from scratch and did the pocket as mentioned above. I made my neck then traced it onto a template blank which I cut out and placed on top of the body for routing with a pattern bit. I added a few pieces of tape to the inside of the template where the bearing rides to make the route come out a hair smaller (tight fit). Its easier to sand or scrape than to add wood back on if you went too big.

Here's a thread of a Tele build, he used a pre-made neck but the steps are the same. -Vinny


Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Create New...