sbskates Posted October 23, 2008 Report Share Posted October 23, 2008 I am building an Sg and i dont really wanna hand carve the chamfer around the body egde. If you built one how did you do it? there are no router bits made this shallow i can find. thanks Quote Link to comment Share on other sites More sharing options...
WezV Posted October 23, 2008 Report Share Posted October 23, 2008 draw a line around the edge and on the top then carve it with a rasp and scrapers. on my last one i actually scraped the bevels a little bit concave to make them look sharper Quote Link to comment Share on other sites More sharing options...
NotYou Posted October 23, 2008 Report Share Posted October 23, 2008 You can also trace it out then use a spokeshave. Quote Link to comment Share on other sites More sharing options...
WezV Posted October 23, 2008 Report Share Posted October 23, 2008 i find that spokeshaves take a lot more skill for this job than a simple rasp, mainly because the grain obviously varies a lot with the shape so you need to be very aware of grain direction whilst carving Quote Link to comment Share on other sites More sharing options...
guitar_player Posted October 23, 2008 Report Share Posted October 23, 2008 i find that spokeshaves take a lot more skill for this job than a simple rasp, mainly because the grain obviously varies a lot with the shape so you need to be very aware of grain direction whilst carving I would probably use rasps or one of these http://www.amazon.com/Makita-GV5000-5-Inch...r/dp/B00004YOKT you would have to be pretty careful and use a finer grit I'd probably stick to rasps just to be safe. Quote Link to comment Share on other sites More sharing options...
kingfisher Posted October 26, 2008 Report Share Posted October 26, 2008 I use an angle grinder with a sanding disk , finish off with sandpaper by hand. Quick and easy. Quote Link to comment Share on other sites More sharing options...
carousel182 Posted October 26, 2008 Report Share Posted October 26, 2008 I just did an sg and used a rasp for the edges.. its not really finished but yea. still gotta use a scraper on it etc Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.