ray Posted September 14, 2011 Report Share Posted September 14, 2011 i am sure someone round here has used one of these and may have found the same as i have the arm is just too high off the bridge - it slides in and screws onto an allen screw that is installed from under the bridge the arm istelf has been drilled and tapped from inside [reverse of fender's] do i really have to cut this arm short and lose the thread? or is it possible to back the allen screw out allowing the arm to slide in further i tried this but it is in so tight i can't budge it with a normal size key possibly locked in so it cant screw out via action from above Quote Link to comment Share on other sites More sharing options...
Tim37 Posted September 14, 2011 Report Share Posted September 14, 2011 Can u just bend it down some I have done that on all my fenders. Quote Link to comment Share on other sites More sharing options...
ihocky2 Posted September 15, 2011 Report Share Posted September 15, 2011 I never thought mine was too high, but I did have the bridge apart so that it was nothing but a pile of parts, nothing attached to each other at all. The allen screw is tight, but did come out. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.