GOG427 Posted February 18, 2004 Report Share Posted February 18, 2004 1. after i have potted the coil where do u attach the wires on the pickup?.. Quote Link to comment Share on other sites More sharing options...
KeithHowell Posted February 18, 2004 Report Share Posted February 18, 2004 Attach your sheilded cable to your coil before potting. You can use the cable to hold it when you hang it into your wax. Make sure the ends of the coil are firmly made off so as you don't put strain on the coil windings. One way of doing this is to solder a much thicker piece of wire to either end of the coil and wind it round the coil a few times then attach your sheilded cable to these two ends. Keith Quote Link to comment Share on other sites More sharing options...
GOG427 Posted February 18, 2004 Author Report Share Posted February 18, 2004 just checking i soldier wires to anywhere on coil or one at each end ..do i soldier to any coil part or ends of coil wire this ---------------- --------------'===== --------------'====== ---------------- or this ---------------- == -------------===== -------------- ---------------- pickup is -------- ------ ----- ----------- shiled wire ===== Quote Link to comment Share on other sites More sharing options...
KeithHowell Posted February 19, 2004 Report Share Posted February 19, 2004 Just solder to the ends of your coil. Keith Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.