Jump to content

uh ohhhhhh


Recommended Posts

I was just thinkin, when i got to route my pick ups and bridge, I will have no problem, but to connect the wires, woul i have to route a little channel and then put some cherry over a bit of the top? this is going to the pots and input jack, or can i do something else?

i was just thinkin and that just dawned upon me

Curtis

Link to comment
Share on other sites

are you putting a pickguard on there, if not get a 12 inch long 1/4 inch bit then drill through the neck pocket from the neck pickup to the bridge then flip the body over and drill from the control cavity to the bridge pickup but be exteremly careful to measure your angle correctly so you dont go through the top and have a hole to deal with

MzI

Link to comment
Share on other sites

no pickgaurd, i was thinking a rear control cavity, then i just have to route the pick up spots and pots then drill it all down into the cavity and then wire it there, easier then i thought, and i guess i could live with it

Thanks for your help

Curtis

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

 Share

×
×
  • Create New...