Well, I have just nearly finished construction of my winder for the pickups that I am making for my current build.
So I will start with the pics, and then the parts list:
Additional images:
Right side...
Left side...
Bearing detail...
Reed switch...
Ok so the parts:
Motor - old sewing machine motor.
Shaft - 8mm (lucky find at Active Surplus, in Toronto)
Bearings - 8mm (recycled from a kids scooter wheel)
Counter - From an old photocopier (also from Active)
Most of you will get how it works but explain for those who don't.
The motor is controlled via the foot switch that came with the sewing machine. The shaft pulley is over sized to help slow down the rpm (that little motor sure can go!). There is a magnet mounted on the shaft pully which activates a reed switch mounted on the back of the unit. This supplies the counter with power on each revolution which in turn causes it to...um...count.
Thusfar I can get about 120-140 rpm out of it without the reed switch failing, which means I am looking at about 1 hour and 11 minutes to wind a 10k pickup, which I can live with.
That's it! I intend to hock a rheostat out of a stove and replace the foot switch with that for more accurate control.
Bye for now!
STV