asscobra

hey guys, ok so having problems with a rotary switch idea n was wondering if anyone here has any advice. neck pickup is a single coil, bridge pickup a humbucker. i have a 6 way 4 pole rotary switch n would like to achieve 1 - hum series 2 - hum parallel 3 - south coil hum + single coil out of phase 4 - south coil hum 5 - all in series... single to north coil hum to south coil hum 6 - single coil would be simple enough.. however i would like the humbucker to have its own volume and tone pots and for the single coil to have its own volume and tone pots in position 3 and 6 but use the humbuckers volume and tone in position 4. this is where it got complicated. https://picasaweb.google.com/lh/photo/R7BuyekgxsJ6CQv2RoYZUGmD18FjeFYVmbjW4fK_FZg?feat=directlink the squiggly line b1-a2 are where i think the circuit is shorting n will make my humbucker run in parallel all the time? but the alternative is b1-c2 which would make my volume n tone only work for south coil? and im not entirely sure my single coil is gonna work the way im wishing either? can anyone take a look and let me know if im on the right tracks? any help or suggestions would be greatly appreciated

I have recently started undertaking a project to install green leds underneath my pickups, I use emgs at the moment and will be running both off the same battery. I would like to install an on/off switch for the leds however I am relatively new to electronics and would greatly appreciate if someone could double check my diagram so that I havnt missed anything. the blue blobs are resistors, the green blobs are the leds. The idea I've had is that if I hook the pickups and positive wire from battery to the common terminal then the pickups will always have power to them, and that if I hook up the leds to one side then when switch is to that side the leds will be on, however is it ok to leave the other side like that with nothin on it? or will this cause problems? The other thought that I had would be to hook up the leds to the common terminal, one side to positive side of battery and other side to ground but I do not know if this connection to the ground is neccesarry or not? Any help or input will be greatly appreciated, Thanks !