Engineer

Sorry lovekraft, I misread your post and didn't see the 1/xtotal. I just read xtotal. Both resistance calculations

The series explanation above is correct. But the parallel explanation is wrong. For parallel, the formula is R1 * R2 etc. divided by R1 + R2 etc. So, for 2- 8 ohm speakers in parallel, you would have (8*8)/(8+8) for a total of 4 ohms. Do a Google on Ohm's Law.

Regardless of the humidity, it could come from moisture. Water is a natural by-product of compressing air. A small investment in an oil/water separator is well worth it.

Thanks for the response. The guitar is an LP Lite, thin body. The color is **** pink/purple. I'm not sure if this is a rare, or valuable, instrument or not. I've done a few nitro finishes, so I pretty much know what I'm doing. The finish on the top is micro-cracked all to hell.

I picked up an '86 LP custom for dirt cheap, $300. The guitar had been knocked off it's stand and the neck broke off at the pocket. That was a piece of cake to fix because it was a lousy glue joint and the break was really clean. The problem is, because of the fall, the finish cracked like crazy. Imagine shattered glass that didn't come apart. I need advice on stripping this guitar without ruining the binding. Does anyone know any techniques other than sanding the whole thing? Or should I just use chemicals and re-do the binding. Thanks.

I can get one for ya if you live in the U.S.

OK, maybe I should have said- I watched the StewMac video "Spray Fininshing Basics" by Dan Erlewine and Don MacRostie. Don did a finish where he painted the colors without masking the binding. Then he scraped the binding and sanded just before the clear coats. Or, to be more more vague but providing information - Check out the StewMac video "Spray Fininshing Basics" by Dan Erlewine and Don MacRostie. The video shows a scraping technique that doesn't require taping.

Sorry, I should have included more info. I saw the technique of scraping on the StewMac video "Spray Fininshing Basics" by Dan Erlewine and Don MacRostie. So, it's not nonsense. I've only built 4 guitars and none of them with binding, so maybe I shouldn't have said anything. Anyway, check out the video, it's pretty good for beginner and intermediate finishing techniques.

You don't have to use tape at all. Just spray over the binding, then scrape it off before clear coating.

Can you tell the difference between Swamp Ash and regular Ash just by looking? If so, I would like to know what to look for. Thanks.

My pickup routing templates have the holes in the proper place so I can attach them with screws. Then the mounting rings screw into the existing holes. As with anything else, PRACTICE ON SCRAP. You can practice a bunch of times on chunks of pine that only cost a few cents each. It's best to get your routing technique down on cheap wood before you mess up a guitar.

Thanks for the warm welcome everyone I'm gonna post my latest project in the Works in progress forum.

I wasn't sure where to post this, so I picked the most active forum. Feylya turned me on to this site yesterday, on another board. Looks like a lot of good info here. Hope I'll be able to contribute. If nothing else, I can pick the brains of people who really know what they're doing.