Jump to content

SpankySpectacular

Members
  • Posts

    7
  • Joined

  • Last visited

Everything posted by SpankySpectacular

  1. I mean't to change the killswitch back to this way on the diagram before this one. I like this way better, i think it makes sense to me. The tone control is wired to the middle, it's just my bad diagram.
  2. Would it be any different if I did it the second way? Only I have lots of spdt switches and only 3 spsts, it would mean hunting some more down. What kind difference would that make? Is it just easier? Or will it sound different? Thanks by the way.
  3. Thanks again, here is a revised version. Is it right? Well its not right because i'm not sure where the 2nd wire fron the single coils goes to, but other than that... The DTDP switch is there to, supposedly, switch between standard humbucker, coils in parallel and coil tapped. But i'm not certain it's correct.
  4. Thanks Mammoth, Few more questions though. Would that be the same in the case of the pickup switches then? I mean using spdt switches and grounding them? While i'm here, do the green wires off the single coil pickups (on my diagram) go to ground? <- Sorted this out. Where does the humbucker ground come from and go to? Which lug/s of the dpdt switch are the output? Sorry if this is really obvious stuff, but i haven't done much like this before.
  5. Hello, i'm new here and am enjoying reading this site a lot. It's given me a lot of ideas for mods and tweaks. Wondered if anyone would be willing to help me with my wiring, as I haven't a clue what i'm doing really and put this together by looking at other plans and stuff. How do i connect the pickups to the switches? Do they need to be connected together before they go to the volume pot? And how does the tone pot connect into the circuit? If there's anything else wrong with it, could you point it out to me please? Thanks.
×
×
  • Create New...