Search the Community
Showing results for tags 'router bits'.
I've bought two new bits recently. The purchase was prompted by the ruination of a neck I was routing for a stratocaster. The bit was decent, I had left no more than 1 mm to route having sanded it 99.5% of the way to the line, and I'm always super careful, but while routing around the heel across the endgrain, it STILL bucked, went bang, and split the neck into firewood. So I finally bit the bullet and bought a couple carbide spiral flush trim bits and while the price tags made me absolutely cringe with horror, no sooner did I start using them and I forgot all about how much I paid (almos
Two bearings are better than one - if the length of your bit shaft and router collet safely allow it.....add another. This 19mm/8mm shaft Luna Tools bearing-guided template bit from neteberg.eu is a prime candidate for an additional bearing. The code for a 19mm OD, 8mm ID shielded bearing is 698ZZ. A few of these cost a couple of Euros. A bargain considering that one "official" bearing costs €6! The collar was loosened with an Allen key and removed. Now's a good time to clean up your cutter and existing bearing. Wipe off any excess packaging machine oil from the new bearing with an a