Search the Community
Showing results for tags 'wiring diagram'.
Found 4 results
-
hoped someon might find this interesting/useful inside vs outside coils like a prs... but from seymour duncan pickups... with semour - the neck bucker is wired exactly the same: fwd wind, fwd polarity (relative) as the bridge. the physical wires for the neck come out on the opposite side -ie the pickup is flipped- so you get screw coils on the outside. so given the pair is wired exactly the sm... when you split both humbuckers (using typical red+white to ground) you'll get both outside coils active... but we don't get hum cancellation. one way to get around this is to take either pickup and physically flip the magnet, then to wire the pickup exactly reverse to the other. ie one goes live->black->white->red->green->ground while the other goes live->green->red->white->black->ground. this wireup takes advantage of that modification such that in (down) normal position on the push pull... you get normal lp operation. pull up and you get outside coils in the bridge position, and inside coils in the neck position. Sort of gives you a "tele in combined mode" in the bridge vs a "strat position 2" in the neck. IMO - much more useful single coils sounds that both feature hum cancelling.
-
I found this on the strat-talk forum (posted in 2011), and while there are videos of it working, I'm wondering if it isn't only half of the signal going to the amp? If anyone has any input, please let me know, I'm looking at adding individual volume controls to a guitar (along with other controls) for blending each pickup individually and want to know if this is a viable option. Thank you all in advance! stracciatella.pdf
-
Guys, I'm installing Fishman Fluence Abasi set into my HB 8string, with a Schaller Megaswitch M. I'm having difficulty figuring out how exactly to connect all this. I'm not sure how the "Fishman Recommended Wiring Diagram" translates to a Schaller switch. If anyone can help me by clarifying this, would be awesome. Thanks.
-
Hello all. I've been a lurker for a little while now, but I'm just now registering because I need help with a wiring layout. Hopefully my drawing isn't too ambiguous. I've used Seymour Duncan Coloring on the Pickups. Basically, will this work? Layout - 2 humbucker, 3-way toggle, 2 push/pull pots, 2-way mini toggle My intent is to have a standard 3 way pickup selector toggle, a 2 way toggle as a master on/off switch. Push/pull pot 1 - Knob going to be a variable knob for blending an amount of coil split on the bridge pickup, the coil to be effected will be selected with push/pull. Down will be outer coils, up will be inner coils. Push/pull pot 2 - Knob will control the blend of coil split on the neck pickup, coil to be effected will be selected with the previous push/pull pot. The push/pull function of this one will bephase switching of the neck pickup. I've gotten some of my information on coil tapping from http://www.smitspickups.com/coiltapping.htm Though I'm honestly not sure I've understood correctly. Is there anyone here who can confirm or deny my schematic? And maybe help me figure it out, if it's possible with my available hardware. I'm not sure if this makes any sense at all... heh. Thanks
