Bearzwud

Thanks everyone for the advice. I figure at this point, either larger bushings (didn't know they come in different sizes) but apparently they do. Or fill and re-drill. Which in that case is not that much of a big deal. I've had to make furniture repairs by filling and re-drilling.

However, thanks again for the advice y'all.

Bear

A brief introduction, I am a skilled furniture builder and a musician of many years, but first time guitar builder.

I received a guitar kit via the internet to try my first build. Its an SG kit.

When I was test fitting all the pieces, the bridge and tail piece anchors fit loosely in their pre-drilled holes.

I can install them and remove them freely.

Now I'm pretty sure they should not be that loose.

So, question being, what can I do to fix this problem?

I am assuming as a craftsman I can,

1. Fill the holes with dowel material and re-drill the holes.

2. Epoxy the anchors in their hole.

3. Exchange the guitar body for another one from the manufacturer/seller.

Thanks y'all