rambler

Can anybody suggest me a where can I find a pre built amp like Fetzer/ruby?

The next example can work right?

http://www.electronics123.com/s.nl/sc.8/category.33/.f ---> http://www.electronics123.com/s.nl/it.A/id...amp;category=33

http://cgi.ebay.it/Audio-Power-Amplifier-I...VQQcmdZViewItem

http://www.oatleyelectronics.com/kits/k064.html

...and what about the "mini tube amp circuit"?

The black "poles" on the cover are just 6 holes...I remove the cover pretty easily, there'a a little bit of wax below..I think that Trisonic picups use a bar magnet insead poles.

Ps The dimensions of trisonics are: Length- 3 InLength, Across Mounting Tabs- 3.65 In., Width- .93 In.

rambler

...are you considering adapting the neck pickup to be a driver, as on my guitar so it works as both...or...replace the neck pickup with a driver.

If you are adapting a pickup to also work as a driver, you may wish to post pictures of your pickups so that we can offer suggestions.

My intention was to have the neck pick up that works as a pickup when I play my guitar "normally" (in series and in phase or out of phase with other Pups), and as a driver in "sustainer mode" (obviously with only the neck pickup activated).

This is a picture of my guitar http://i143.photobucket.com/albums/r140/ra...pg?t=1168243436

..the pickups mounted are 4 Burns Trisonics V ( http://www.brianmayworld.com/image6.jpg )

I'm building an homemade guitar with 3 low impendance singlecoil pickups (6.4K) and I want to wire it with 3 on/off and in/off phase switches for every pickup (as shown at http://www.brianmaycentral.net/wiring.gif).

...I've built 2 years ago a guitar (similar to kerroc intention's construction) with 4 low outout PUPs, wired this way

http://i143.photobucket.com/albums/r140/ra...pg?t=1168195082

How can I rewire it, inserting the sustainer, mantaining then a sustainer/pickup in the neck position?