bassman Posted February 11, 2005 Report Share Posted February 11, 2005 I am working on a mahogany/spalted maple body. I was wondering if I may encounter problems with finishing (I will be using ktm-9) after using CA to harden the spalt, and then later using epoxy as a grain filler? I would think the two adhesives would be compatible- but I am a bit concerned about long term finishing problems. PS> of course I will post about the results of the new KTM-9 after I finish this baby up... assuming no probs with CA and epoxy mixing. Quote Link to comment Share on other sites More sharing options...
Devon Headen Posted February 11, 2005 Report Share Posted February 11, 2005 They should be fine. I'd do a test on some scrap first just to be sure. It's always better safe than sorry. Quote Link to comment Share on other sites More sharing options...
bassman Posted February 11, 2005 Author Report Share Posted February 11, 2005 Thanks..........I know it will be fine i the short run, it is down the road that I am curious about- of course I am already testing- but it is hard to test the future ya know? Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.