darkshadow54321 Posted June 10, 2009 Report Share Posted June 10, 2009 (edited) Hello everyone. I came across these bits: http://www.smallwonder-music.co.uk/shop/To...Bits/p-123-454/ Any ideas on how they'd compare to the Stewmac bits? They're a bit cheaper and located in the UK (which is good for me as I save on shipping) and seem to be essentially the same thing. The Stewmac ones are 'reverse spiral' bits. Does that make any difference? Also, what size would you recommend? My plan is to route close to the outline but then finish it off with chisels/razor blades to ensure a good fit. I was thinking of getting the T35 - 1.6mm (1/16"). Thanks for the help! Edited June 10, 2009 by darkshadow54321 Quote Link to comment Share on other sites More sharing options...
Bmth Builder Posted June 10, 2009 Report Share Posted June 10, 2009 For inlays you probably want upcutting bits to remove the wood as you cut? Quote Link to comment Share on other sites More sharing options...
Woodenspoke Posted June 10, 2009 Report Share Posted June 10, 2009 For inlays you probably want upcutting bits to remove the wood as you cut? Also if you want cheap down cut bits look for a metalworking store and order a milling bit in the same size. Same thing only 1/3rd the price. Quote Link to comment Share on other sites More sharing options...
darkshadow54321 Posted June 11, 2009 Author Report Share Posted June 11, 2009 Also if you want cheap down cut bits look for a metalworking store and order a milling bit in the same size. Same thing only 1/3rd the price. Do you mean something like this, but in a different size? http://cgi.ebay.co.uk/5x-0-5mm-Carbide-Mil...1|293:1|294:200 I'm a little confused now... I thought a downcut bit would be preferable for inlay because you're seeking to create perfect crisp lines to fit the inlay piece. An upcut bit would leave slightly less crisp lines due to the cutting action, no? Also, couldn't you just use a vacuum system attached to the dremel router base to get the chips/dust out of the way while using a downcut bit? Quote Link to comment Share on other sites More sharing options...
Woodenspoke Posted June 12, 2009 Report Share Posted June 12, 2009 Also if you want cheap down cut bits look for a metalworking store and order a milling bit in the same size. Same thing only 1/3rd the price. Do you mean something like this, but in a different size? http://cgi.ebay.co.uk/5x-0-5mm-Carbide-Mil...1|293:1|294:200 I'm a little confused now... I thought a down-cut bit would be preferable for inlay because you're seeking to create perfect crisp lines to fit the inlay piece. An up-cut bit would leave slightly less crisp lines due to the cutting action, no? Also, couldn't you just use a vacuum system attached to the dremel router base to get the chips/dust out of the way while using a down-cut bit? Correct on the bits. You can use any bit down or up doesn't matter. I have not found much of a difference if the bit is sharp. Buy what's cheapest. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.