XvXBigPappaXvX

BUMPPPP!!!!! Ok I have one question which the tutorials dont answer (to my knowledge) Due to the very small angles at the point of our guitar we are goin to have a hard time Beveling it. We were told to start with a 45 bevel bit the slowly dig deeper but dont go close to the points, then hand sand the bevels to 60 degrees and also do the points. Any easier ways of doing it without destroying the body???

Yes we have a custom samick neck.

Please we need advice!!!!!!!!!!!!!!

White is one over our choices. We are prolly gunna do Silver body with black bevels, and reverse on the back side. the only problem with the photoshop is the fret board, it should be darker.

We recut the lower horn about 2 weeks ago. So problem solved it is just a little shorter. But it solved the problem Next we are gunna bevel it. But we have a problem......We need to find a 23 degree beveling bit with a 1/4 in or 1/2 shank. Anyone know where to find one??

Hey, I'm new to this forum. My friend and I have been building a guitar for about 2 months now. It is a design of His very own (we think) the specs are: 2 piece alder body SG style bevels (top and bottom) Maple neck Ebony fret board Floyd rose EMG HZ-H4 (neck) Screamin Demon (bridge) (well i guess these are finished spec) pron: That my friend not me (only good picture of the body) i also had someone photoshop it but not in the color scheme we want it So what's your opinion on the guitar?? Any mistakes we made? Any suggestions? Oh yeah what you see in the picture is how far we are now (lol) Thank you Jordan