cgforero

HI all. I installed a LR Baggs TBridge and a CRTL-x preamp. Everything works fine in mono mode. But in stereo mode, using an Y-cable, the magnetic pick up signal gets an insane amount of noise. I don't think that this is a ground loop as the noise just get there as soon as the stereo plug is being inserted in the jack hole, simply pluging the magnetic signal inside the amp and leaving the piezo signal unplugged. Does anybody who has experience with the CTRL-X preamp have any idea of what can be wrong? Thank you. Regards.

Thanks a lot. Best Regards. César PS.-Very nice guitars at your site.

Hi all. I have installed an LR Baggs Active X preamp on my guitar. I would like to put a small knob to control its pot. I mean a knob just to cover the control, not as big as a standard strat or dome knob. Does anybody know where I could find something similar in an Internet shop? Thank tou very much. Regards.

Hi, I am wiring a typical 2 humbucker, 3 switch selector, 1 volume and 1 tone guitar with tunomatic bridge. Where should I have the final common ground? Do I have to drill a hole to wire the bridge to that ground? In that case which part of the bridge should be soldered to ground? I am also shielding the cavity with Conductive Copper Tape. Should I wire the tape to ground? Can anyone tell me where to find good photos of electronics. I understand the diagrams but I would like to find photos because I get lost big-time. Thank you very much. Regards.