Jump to content


Recommended Posts

I believe it's any way you want it but keep in mind that if you have to adjust the truss rod nut, and it's mounted at the neck heel, you have to remove the neck screws if it's a bolt on, or if it's neck thru cut an access hole in the body.

The most popular place is at the headstock though since you can get to the truss rod nut without removing the neck.

Link to comment
Share on other sites

I am pretty sure it goes to the back of the neck. I dont think PerryL understood your question.... The adjustment peg sticks out at the headstock end... and you were asking if the longer piece is on top or bottom right? If so... I say bottom!

Link to comment
Share on other sites

its towards the back of the neck. that way you get maximum clearence for your truss rod cover. if you had a angled headstock it would actually stick out pretty far if you put it the wrong way.

ps- its 'wrench', not rench

Edited by asm
Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Create New...