New Wiring Diagram

[ansil]

what do you guys think of this wiring diagram.

Seymour Duncan sh-2 jazz neck

Dimarzio single coil nice wide flat output balanced pole pieces

fender single coil Texas special slight over-wind with staggered pole pieces

mini emg-81 . although they don't make an emg-81 in a single coil package but, i found a hot rail style maker with a similar wiring and ceramic magnet. so i copied the circuit.

for those that don't want to take the time to look at the schematic

5.Duncan with cap mod

4.dimarzio and CC Duncan

3.dimarzio

2.dimarzio and fender singles

1.MINI 81

5.Duncan with cap mod

4.dimarzio and CC Duncan

3.Duncan no cap mod and mini 81

2.dimarzio and fender singles

1.MINI 81

some will wonder why i don't just coil cut a hum bucker in the bridge however i don't really like many passive bridge pickups. if i find a good one then to me it doesn't sound good coil cut to me. So i figured for my playing style I use the bridge pickup for ripping out leads and melodies. most of my solo stuff is on the neck pickup. clean stuff is always single coils so one of these schematics is going to do the job. let me know what you guys think. thanks

also i forgot the tone pot is a linear taper pot that has been turned into a no load pot but its zero point is in the middle so one way is a smaller cap for slight treble roll off and the other is for a deeper roll off and in the middle is out of circuit.

500k vol, and 1 M tone

[ansil]

well never mind guys i didn't get any feedback and its done now so it doesn't really matter