oli

THERE IS AN ARTICLE IN MARCH 2004 ARCHIVE ON ALLTHINGSGUITAR.COM CALLED VOLUME POT MOD THAT MAY BE OF INTEREST IF YOU PLAN ON USING THE CAPASITOR AND RESISTOR FOR THE TREBLE BLEED ON THE VOLUME POT

dont be so hard on your self thanks for giving it some thought i think we got what we need to get er done

i was doing some surfing while waiting for more input and found a site called all things guitar and they show the capasitor 681 iKV wired to the volume pot will i still need to install a cap on the tone pot also (TBX or 1Meg) if anyone is still with me here

yup they came with a capasitor and a resistor but as i said the diagram that came with them makes no referance to them the capasitor is a 680pf and i think the resistor is a 220k the diagram however shows .022uf soldered to the tone pot so if i should use them i guess i have to find out how and where they get wired in

I am wiring a set of fender noiseless SSS pickups into a project strat and i am unsure of which capasitor i need for the tone pot some call for .022uf and some .05uf? the pickups came with a 681 1KV but they dont mention that on the diagram all i can find in the local electronics shop is an .022 -100volt and a .022 poly film cap 50wvdc this is my first wiring project and i want to get it right i hope this is clear enough

Devon said he wasnt to knowledgabl about term bridges and i dont recall you answering follow up question is there a problem? sorry. i figure i'd get some more input as to what to fill the holes with ect. figured that was more likely to happen if i repost. in any case if anyone else has this problem or a stripped screw hole try theZAR EPOXY Wood Patch seems pretty strong and supposedly takes on the same density as the wood anyway didnt mean to ruffle any feathers there haggardguy

if you have a problem with an ebay seller they have an arbitrator i have used this and got some satisfaction as it turned out it was just a mistake good luck

Have strat body with 6 holes for trem drilled 25 and 3/8s from nut which is to far by 1/8" what is the best remody? I thought of drilling and dowling these holes the cavity is in the right place need some expert help as to wether this would be an acceptable method

I was measuring from bridge srew to bridge side of nut i checked it and it seems to be the same for each string position and center

Have strat body with 6 holes for trem drilled 25 and 3/8s from nut which is to far by 1/8" what is the best remody? I thought of drilling and dowling these holes the cavity is in the right place need some expert help as to wether this would be an acceptable method