Hunter Posted June 27, 2006 Report Share Posted June 27, 2006 Okay, so this is probably a totally n00b-ish question, but I can't find a diagram anywhere. This is the way it's wired now: http://www.seymourduncan.com/support/schem...dard_pbass.html Which wires get removed and/or resoldered? Sorry to bother you guys, but I have very little knowledge of electronics... Quote Link to comment Share on other sites More sharing options...
j. pierce Posted June 27, 2006 Report Share Posted June 27, 2006 See the wire off the far right lug of the volume pot, connected to the tone pot? Remove that one. Leave the other wire on that lug (going from the pickup to that far right lug of the volume pot) alone. Quote Link to comment Share on other sites More sharing options...
masterpuppets Posted June 27, 2006 Report Share Posted June 27, 2006 Disconnect the wire going to the tone pot from the input lug on the volume pot ( the lug where the white or yellow wire from pickup is connected).Actually,you don't have to unsolder it I don't think.Just clip it off. Quote Link to comment Share on other sites More sharing options...
Hunter Posted June 27, 2006 Author Report Share Posted June 27, 2006 (edited) Oh snap, and that's all? Awesome. Thanks alot guys. EDIT: Okay, so, it turns out my diagram was different than that, so I had to resolder a few wires here and there, but I got it to work, and it sounds a bit clearer now. So, thankyouthankyouthankyou~ Edited June 27, 2006 by Hunter Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.