Captain Sociable Posted May 10, 2008 Report Share Posted May 10, 2008 AAAARGH! so I havent looked at my strat body since I finshed dying it. There is a small section of the veneer that has pulled away from the body since it dried. Can I put a small amount of glue on a razor blade, slide it between the body and the veneer then clamp it down without there being any further damage? Could I use grain filler and then sand it? My schedule has come to a screeching halt until I am able to repair the veneer. Quote Link to comment Share on other sites More sharing options...
low end fuzz Posted May 10, 2008 Report Share Posted May 10, 2008 why not some super runny ca glue? if its on a rounded/shaped edge you can put the glue in and roll a rubber roller (like from an o.s.sander) and there you go; if you make a mess and have to fix it, you might screw your colour so be careful Quote Link to comment Share on other sites More sharing options...
wohzah Posted May 12, 2008 Report Share Posted May 12, 2008 I would vote for the razor blade technique you described. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.