bileshake Posted August 28, 2017 Report Share Posted August 28, 2017 I've got a reverse pointy head stock neck that came from Stew Mac in the 90's. I'm ready to use this neck but I'd like to dress it up a little. I'm thinking of either adding binding or apply veneer to the face to dress it up a little. If decide on binding should I sand the edges back so routing the edge doesn't chip. Quote Link to comment Share on other sites More sharing options...
Norris Posted August 29, 2017 Report Share Posted August 29, 2017 Cutting a binding rebate by hand would be very difficult. The best results would be by using a small router with an edge guide, and sanding is not likely to help much. A good sharp bit and a steady hand will get the best results, but may not be that easy around the pointy bits. However, if you're thinking of veneer AND binding, you could always cut the veneer slightly inset to give yourself a binding rebate. Quote Link to comment Share on other sites More sharing options...
Crusader Posted September 3, 2017 Report Share Posted September 3, 2017 On 28/08/2017 at 10:49 PM, bileshake said: I've got a reverse pointy head stock neck... On 29/08/2017 at 7:12 PM, Norris said: ... a small router with an edge guide Sorry this is a bit kind of late, but Wouldn't it be best to use a router bit with a wheel that Stewmac sell? with the correct depth to suit the binding If I were doing this my biggest fear would be the the trimmer tipping when going round the pointy end. I would make up a jig to support the trimmer so this can't happen. I would somehow secure the headstock to a board through the tuning peg holes and then screw pieces of timber the same thickness as the headstock about an inch away (or more, whatever keeps the router bit clear of the job) Use a good sharp bit as Norris said and go "backwards" with the router to avoid chipping, a little bit at a time. Don't router the full depth all at once, go about a third at a time. And the last time go in the proper direction to make sure its clean, no bumps I've might have photos to give a clear idea of what I mean and post them later Quote Link to comment Share on other sites More sharing options...
bileshake Posted September 7, 2017 Author Report Share Posted September 7, 2017 Thanks bud, there's a couple things i didn't for see. I was just picturing the chipping specially with a already painted headstock. I'm gonna give this a shot as soon as I have the binding in hand and know forsure what the nut is gonna be. Quote Link to comment Share on other sites More sharing options...
bileshake Posted September 7, 2017 Author Report Share Posted September 7, 2017 You made me think, maybe I'll use a 13"x 13" block of plywood with a hole cut in the center the shape of the headstock. It's a good start. Thanks again. Quote Link to comment Share on other sites More sharing options...
Prostheta Posted September 15, 2017 Report Share Posted September 15, 2017 Already painted? Ah, well that's just asking for trouble since it's an added complication. My binding cutter is downshear which may help a little with existing paint. It certainly helps for reducing chippy edges on wood otherwise. Quote Link to comment Share on other sites More sharing options...
bileshake Posted September 19, 2017 Author Report Share Posted September 19, 2017 Thanks for the info that actually sparked some ideas of creating a small jig for binding head stocks. I thought that i might strip the paint off anyways just to dress it up a little. maybe veneer matching the body... Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.