Curtis P Posted May 16, 2004 Report Posted May 16, 2004 How do I cut the fret? just mesure it a little bit bigger and then cut with side cutters?? Thanks Curtis Quote
kings_x Posted May 16, 2004 Report Posted May 16, 2004 I used a Dremel with a cutting disk. It made a pretty clean cut and didn't bend the end of the fret like side cuts do. You just have to be careful not to get the fret too hot which causes it to change colors. Quote
krazyderek Posted May 16, 2004 Report Posted May 16, 2004 I used a Dremel with a cutting disk. It made a pretty clean cut and didn't bend the end of the fret like side cuts do. You just have to be careful not to get the fret too hot which causes it to change colors. i only used a dremel for 2 frets when they were on the neck, and i found the heat was burning the wood, so i had to resort back to the snipers Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.